Cisco Aironet 350 not working in FC2

[captnapalm]

PCI version, was working fine with the Cisco driver in RH9 w/kernel 2.4. Now using kernel 2.6.5, and no luck. It's even detected by Kudzu, which is wasn't in RH9. I've Googled like crazy, heard of plenty of people having trouble w/kernel 2.6 but no solution.

Anybody get this working out there?

thanks,
luther

[gnava]

Hello

i have my aironet 350 working in FC2. First i had some problems with the network device configurator in
the gnome menu, but doing configuration manually, there is no problem. The card is detected and the interface is associated with no problem

i have my wired interface eth0, so, my wireless interface is eth1

this is my ifcfg file: (/etc/sysconfig/network-scripts/ifcfg-eth1)

------------
DEVICE=eth1
BOOTPROTO=dhcp
HWADDR=00:01:12:23:34:56 <----- you must replace this value with your nic mac address
ONBOOT=no
TYPE=Ethernet
------------

Create / edit this file whitout the card plugged in, insert your card and if your AP is properly working
you should have the eth1 interface up.

If you have any doubt, write me

Gabriel Nava
Morelia, Mexico