oshman
2005-05-04, 08:33 PM CDT
Hey all,
I'm still (aarrrggg) trying to get wireless configured. I think I am 1 step further though. I downloaded the madwifi linux drivers for my Atheros AR5001X+ card with 5212 chipset. So far so good.
I tried configuring the card through System Tools -> Internet Configuration Wizard only to stall out because the card was not under the listed hardware.
So I teird to configure at boot up. During boot up, when the system is "checking for new hardware" - Kudzu (Redhat hardware detection tool) is activated and prompts set up of newly found hardware.
- It asks to configure new hardware - where I proceed
- It detects an "Atheros Communications" peice of hardware - I proceed further
- It asks for IP configuration -> either through DHCP or manual setup
- I try both and the result is
CRASH !!!!! at "enabling swap space" :mad: :mad:
Has anyone experienced this, and does anyone have any advice?
I'm still (aarrrggg) trying to get wireless configured. I think I am 1 step further though. I downloaded the madwifi linux drivers for my Atheros AR5001X+ card with 5212 chipset. So far so good.
I tried configuring the card through System Tools -> Internet Configuration Wizard only to stall out because the card was not under the listed hardware.
So I teird to configure at boot up. During boot up, when the system is "checking for new hardware" - Kudzu (Redhat hardware detection tool) is activated and prompts set up of newly found hardware.
- It asks to configure new hardware - where I proceed
- It detects an "Atheros Communications" peice of hardware - I proceed further
- It asks for IP configuration -> either through DHCP or manual setup
- I try both and the result is
CRASH !!!!! at "enabling swap space" :mad: :mad:
Has anyone experienced this, and does anyone have any advice?