zeky
2005-09-13, 02:22 AM CDT
hello!
I have a problem with running Fedora in vmware. I want to setup a cluster in vmware, so I'm trying to configure two exactly the same NICs (they both use the same module) as eth0 and eth1.
The problem is that both NICs are using the same module, thereforer i don't know how to configure my system to not treat them as one card :confused: The system still thinks that this is the same device, althought it's not. So it's configuring both the same. I've tryed to change by hand the ifcfg-eth0 and ifcfg-eth1 but no luck.
I was googling for the problem, but no luck :(
Any ideas?
I have a problem with running Fedora in vmware. I want to setup a cluster in vmware, so I'm trying to configure two exactly the same NICs (they both use the same module) as eth0 and eth1.
The problem is that both NICs are using the same module, thereforer i don't know how to configure my system to not treat them as one card :confused: The system still thinks that this is the same device, althought it's not. So it's configuring both the same. I've tryed to change by hand the ifcfg-eth0 and ifcfg-eth1 but no luck.
I was googling for the problem, but no luck :(
Any ideas?