Lenovo X301 fingerprint reader in Fedora 11

[zirb]

Hi, does anybody know if AuthenTec's fingerprint reader in the Lenovo X301 (and maybe X300?) laptop works in Fedora 11 with some kind of driver?
Thanks

$ lsusb -vvv
Bus 003 Device 002: ID 08ff:2810 AuthenTec, Inc.
Device Descriptor:
  bLength                18
  bDescriptorType         1
  bcdUSB               2.00
  bDeviceClass          255 Vendor Specific Class
  bDeviceSubClass       255 Vendor Specific Subclass
  bDeviceProtocol       255 Vendor Specific Protocol
  bMaxPacketSize0         8
  idVendor           0x08ff AuthenTec, Inc.
  idProduct          0x2810
  bcdDevice           17.03
  iManufacturer           0
  iProduct                1 Fingerprint Sensor
  iSerial                 0
  bNumConfigurations      1
  Configuration Descriptor:
    bLength                 9
    bDescriptorType         2
    wTotalLength           32
    bNumInterfaces          1
    bConfigurationValue     1
    iConfiguration          0
    bmAttributes         0xa0
      (Bus Powered)
      Remote Wakeup
    MaxPower              100mA
    Interface Descriptor:
      bLength                 9
      bDescriptorType         4
      bInterfaceNumber        0
      bAlternateSetting       0
      bNumEndpoints           2
      bInterfaceClass       255 Vendor Specific Class
      bInterfaceSubClass    255 Vendor Specific Subclass
      bInterfaceProtocol    255 Vendor Specific Protocol
      iInterface              0
      Endpoint Descriptor:
        bLength                 7
        bDescriptorType         5
        bEndpointAddress     0x81  EP 1 IN
        bmAttributes            2
          Transfer Type            Bulk
          Synch Type               None
          Usage Type               Data
        wMaxPacketSize     0x0040  1x 64 bytes
        bInterval               0
      Endpoint Descriptor:
        bLength                 7
        bDescriptorType         5
        bEndpointAddress     0x02  EP 2 OUT
        bmAttributes            2
          Transfer Type            Bulk
          Synch Type               None
          Usage Type               Data
        wMaxPacketSize     0x0008  1x 8 bytes
        bInterval               0
Device Status:     0x0000
  (Bus Powered)

[seanb]

I dont really know as I am new to Fedora and Linux in general however the fingerprint reader in my Lenovo T60 worked perfectly after I installed Fedora 11. In fact pretty much everything on my Thinkpad just worked. My fans are a little flakey sometimes but thats about it.

[zirb]

Based on the following page, the X301 fingerprint reader is AuthenTec 2810 (confirmed in above lsusb output), and this is not yet supported by fprint:

http://www.thinkwiki.org/wiki/Integr...erprint_Reader

Your T60 is a UPEK fingerprint reader which is supported.