Well, I tried the preupgrade method for upgrading FC10 to FC11 and all seemed to be fine until the final upgrade after reboot. I am not totally a newbie, but I cannot figure these three issues out:
1 - My RAIDS (RAID0 and RAID1) cannot be mounted. mdadm --detail /dev/md0(1) sees all drives and they are marked "active, not started." /etc/mdadm.conf shows correct information. Each drive has a superblock. The only thing I see in dmesg is an "md: personality for level 0 is not loaded!" I cannot mount /dev/md0 or /dev/md1 as I get a "mount: you must specifiy the filesystem type." I try mount -t ext3 and that doesnt work either. I must retain data on both RAIDS.
2 - My External USB drive is not recognized at all by the kernel upon boot and therefor cannot be mounted.
3 - Both of the ehternet NIC's are not recognized anymore. Both eth0 eth1 do not show up in ifconfig and I see nothing in dmesg that it tries to load them. lspci shows "Realtek RTL8111/8168B." Both NICs worked right out of the box in FC10, no problems.
In my best opinion, I feel I am missing modules or something related to that. Did my new kernel that I am running on (2.6.27.41-170.2.117.fc10.x86_64) not have all modules built in or compiled?
Your help is greatly appreciated. If this doesn't seem to be an easy fix, my priority is the data on those RAIDS!
SToGE
Linear Mode
